Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Local SPAN on 4948, amount of traffic is not equal

Hi All,

I have the cisco switch WS-C4948 running IOS 12.2(46)SG and local span session configured:

sw-4948>show monitor

Session 6

---------

Type : Local Session

Source Ports :

Both : Gi1/5-11,Gi1/21

Destination Ports : Gi1/4

Encapsulation : Native

Ingress : Disabled

Learning : Disabled

the total sum (input and output) of the traffic of source ports is not equal to output rate on destination port

Any idea what's wrong?

Thank You

j.mozolik.,

sw-4948#show int g1/4 | i rate

Queueing strategy: fifo

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 760000 bits/sec, 305 packets/sec

sw-4948#

sw-4948#show int g1/5 | i rate

Queueing strategy: fifo

5 minute input rate 654000 bits/sec, 277 packets/sec

5 minute output rate 726000 bits/sec, 399 packets/sec

sw-4948#show int g1/6 | i rate

Queueing strategy: fifo

5 minute input rate 1385000 bits/sec, 330 packets/sec

5 minute output rate 1081000 bits/sec, 374 packets/sec

sw-4948#show int g1/7 | i rate

Queueing strategy: fifo

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

sw-4948#show int g1/8 | i rate

Queueing strategy: fifo

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

sw-4948#show int g1/9 | i rate

Queueing strategy: fifo

5 minute input rate 779000 bits/sec, 315 packets/sec

5 minute output rate 803000 bits/sec, 450 packets/sec

sw-4948#show int g1/10 | i rate

Queueing strategy: fifo

5 minute input rate 677000 bits/sec, 199 packets/sec

5 minute output rate 568000 bits/sec, 213 packets/sec

sw-4948#show int g1/11 | i rate

Queueing strategy: fifo

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

sw-4948#show int g1/21 | i rate

Queueing strategy: fifo

5 minute input rate 844000 bits/sec, 489 packets/sec

5 minute output rate 776000 bits/sec, 334 packets/sec

1 REPLY
Silver

Re: Local SPAN on 4948, amount of traffic is not equal

5 minute average measures interval of about 30 minutes. So there are two possible reasons.

1. set load-interval to 30 (seconds)

2. Counters do not correspond to the mirrored information.

As a side note: One TAC case that i saw about counters were deemed as a cosmetic bug and the results had to be read elsewhere.

311
Views
0
Helpful
1
Replies