Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Login Problem

Dear seniors,

We are not able to access the Router (7206VXR) on today day before yesterday we were work on that we were accessing the router through putty because telnet is disable on router and Network Error Connection Refused. This error we are getting while accessing the router remotely…so what could be the problem how I can resolve this issue

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Login Problem

HI Sasi,

As discussed, since the VTY Session are not timed-out configure the VTY Line as below:

line vty 0 4

"exec-timeout 3 0"

The Exec-timeout will help to clear the Lines after certain period of time.

Best Regards,

Guru Prasad R

9 REPLIES

Re: Login Problem

HI Sasikumar, [Pls Rate if HELPS]

In the Configuartion under "Line VTY" have you done any changes like "transport input none" command

because this command will not allow anyone to login via the VTY Sessions by preventing the Telnet Access on Port 23. Try login via Console and remove such commands if any.

Is the services of the Router are working fine ?

Hope i am informative.

Pls Rate if HELPS

Best Regards,

Guru Prasad R

New Member

Re: Login Problem

we didn't change any thing on router previos we were logging throug putty only now we not able to access

New Member

Re: Login Problem

we are using login that router through SSH

Re: Login Problem

HI Sasikumar,

Are you able to login via Console and check any un-usual logs regards to authentication via VTY ?

Regards,

Guru Prasad R

New Member

Re: Login Problem

yes we access the router through console and we cleared the lines VTY because login 15 was there now we solved this issue

Re: Login Problem

Hi

U need to use a terminal software which supports SSH try secreCRT.

Thanks

Mahmood

New Member

Re: Login Problem

yes we are using putty s/w

Re: Login Problem

HI Sasikumar,

Can you paste the line VTY Config and AAA Configuration ?

Regards,

Guru Prasad R

Re: Login Problem

HI Sasi,

As discussed, since the VTY Session are not timed-out configure the VTY Line as below:

line vty 0 4

"exec-timeout 3 0"

The Exec-timeout will help to clear the Lines after certain period of time.

Best Regards,

Guru Prasad R

131
Views
0
Helpful
9
Replies