Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Looking for Direction in setting up AP541n with POE

                   I have 4-Cisco AP541n WAP's in a cluster.  I have a mix of Switches, primarily Cisco.  I would like to set 1 of the AP541n WAP's with POE using the Cisco SG300 Switch.  The switch resides in a "closet"in the NW corner of a Hangar along with the AP541n I want to set up with POE.  BUT I want to relocate the AP541n to the NE corner of the hangar using the POE setup.  This will place the AP541n about 125' away from the SG300.  I assume I can use a CAT5, CAT5e or CAT6 cable but think there has to be some configuration on the SG300 that will be required.  I believe both devices have the POE capability but cannot find any documentation on "how to" set it up. 

Any assistance would be helpful.

Thank you,

Michaelle Olson

125
Views
0
Helpful
0
Replies
CreatePlease to create content