Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Loopback Interface on Cat3750G-24TS-E

Hi,

yust a "simple" question... i'm using first time the switch above with IOS C3750-IPSERVICES-M, Version 12.2(25)SEB4.

Is there a known reason, why the number for Loopback interfaces is 'limited' to 64?

regards

Frank

Is there a reason

1 REPLY

Re: Loopback Interface on Cat3750G-24TS-E

Well usually there is no need for more than one or two Loopback interfaces.

Generally as Loopbacks are created in software the only thing you need for them is enough memory.

This is therefore a software limit (I was not actually aware of it), which only the programmer could tell why it is in place.

Hope this helps

Martin

160
Views
0
Helpful
1
Replies