Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Loopback test

Hi all,

What is different between HDLC loopback test ( pins assignment 1,2,4,5) and ELL loopback test ( pins assignmet 1,2,3,6)?

How many type of loopback test ?

Is depend on interface type?

Thanks,

Max

1 REPLY
Silver

Re: Loopback test

See loopback test we can do too many ways... depend upon our analytical skill.

Basic purpose to do Loopback is complete the curcuit and see response. That you can use for troubleshooting on hop to hop and analyse the problem point of area.

Most od types are :

loopback (controller el)

loopback local (controller)

loopback local (interface)

loopback remote (controller)

and you can test them by http://www.cisco.com/en/US/products/ps6441/products_command_reference_chapter09186a00804a3c48.html#wp1007856

You can also test Interfaces by using commands

sh test {MOD}

show diagnostics mod (MOD)

For above command referance you can see on:

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015bfd6.shtml

Regards,

Dharmesh Purohit

337
Views
0
Helpful
1
Replies