Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

loopback test

Hi

I have 3600 router which is connected over E1 link to other router.

I want to give soft loop from router toward BERT meter, can it possible.

I hve done following things

config t> int Se0/1

then go to loopback command and execute , but BERT meter could not detect that loop , is there any other way to give loopback toward BERT side

-Vinod

1 REPLY

Re: loopback test

Try to give a hard plug loop towards the Bert meter by shorting pins 1-4 and 2-5

Then use the same connector on your module and see whether the controller detects the loop.

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a008010059a.shtml#topic1

HTH

Narayan

464
Views
0
Helpful
1
Replies