Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Losing connection to PIX on 506-E

When I access my PIX remotely or from the LAN it will drop the connection about 10 mins into configuring anything, even if I'm using the interface and monitoring. I then have to shut off my browser, wait a few minutes, then connect again. This is happening repeatably even with resets.

Any suggestions would be greatly appreciated.

2 REPLIES
Silver

Re: Losing connection to PIX on 506-E

Are you access by PDM or By Telnet ?

If PDM what is version no?

Regards,

Dharmesh Purohit

New Member

Re: Losing connection to PIX on 506-E

Please refer to this topic as this thread was duplicated by mistake:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddf29b3

To answer, yes I am using PDM manager 3.0 on a PIX 506-E

95
Views
0
Helpful
2
Replies