Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

lost SPA-2XT3/E3 after fabric error

On a 7606 router, a 7600-SIP-200 module with SPA-2XT3/E3 installed lost both DS-3 circuits after getting the error message:

SLOT 2: Aug 2 02:11:27.725 UTC: %SSA-5-FABRICSYNC_REQ: Fabric sync

requested on Primary channel (2)

SLOT 2: Aug 2 02:11:27.725 UTC: %SSA-4-FABRICCRCERRS: 5 Fabric CRC

error events in 100ms period

The only way to recover the circuits was to issue the command: hw-module module 2 reset

CCO documentation says that the Fabric error messages are informational and require no action.

Has anyone seen this before or have suggestions on how to avoid losing circuits again?

1 REPLY
Silver

Re: lost SPA-2XT3/E3 after fabric error

227
Views
0
Helpful
1
Replies