Hi, I?ve got a PIX 501 with v6.1 loaded (I know, very old). I would prefer not to change the version but I need to create an access-list allowing only several source-mac traffic from inside to outside. In version 6.3 I see the mac-access command but it is not recognized in 6.1, is there any way to do this task without upgrading?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...