By running "debug ip dhcp server events" at enable mode - the DHCPD binding information was able to be sent to the syslog server. That's exactly when I wanted to have happen. But the problem is that if the DHCP router reboots I would need to execute that same debugging line else lose my DHCP assignment/binding logging. Is there any way to make such debugging persistent (still in effect even after reboot?) Or is there another means of having a DHCP enabled router send bindings out via syslog?
Jul 10 16:26:37 10.1.6.5 36: 35w3d: DHCPD: assigned IP address 10.1.6.253 to
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...