Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Maximum Characters In A Single Command

Hello,

Is there a way to increase the maximum allowed characters in a single IOS command? I am trying to configure a big list of vlans in "encapsulation dot1q" command in ASR903 but I am reaching a point where I am unable to add any new character. I noticed this character count limitation is the same across IOS/IOS-XE, is this limit configurable?

service instance trunk 1 ethernet

  encapsulation dot1q 55,58-60,.......

regards,

Everyone's tags (6)
121
Views
0
Helpful
0
Replies
CreatePlease to create content