11-01-2011 09:26 PM - edited 03-04-2019 02:07 PM
hello,
am use router Cisco 7206VXR (NPE-G2) ram 1G now am enable bgp routing full route aboute 400K record , ospf routing
maximum traffic throughput is 400 Mbps but the cpu utilize is 80%
Could you tell me this is normal status or not??
11-01-2011 09:51 PM
This about the right figure. The entire NPE G2 blade (not per interface, mind you) can push about 1Gb of traffic (half duplex and no encryption).
11-01-2011 11:50 PM
What is mean 1 G and half dulplex ?
11-02-2011 12:09 AM
show process cpu sort - from my router.
CPU utilization for five seconds: 57%/56%; one minute: 62%; five minutes: 61%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
5 59435312 3079985 19297 0.31% 0.61% 0.62% 0 Check heaps
142 90864 1397439722 0 0.23% 0.18% 0.17% 0 HQF Shaper Backg
273 11384 1404 8108 0.23% 2.34% 1.07% 4 SSH Process
270 139390900 46654520 2987 0.15% 1.57% 1.91% 0 BGP Router
2 170672 1173612 145 0.07% 0.02% 0.00% 0 Load Meter
117 64812 19337221 3 0.07% 0.02% 0.01% 0 TCP Timer
87 7251740 42320499 171 0.07% 0.10% 0.09% 0 IP Input
112 21868 8128979 2 0.07% 0.00% 0.00% 0 CEF: IPv4 proces
110 5922320 17561471 337 0.07% 0.06% 0.07% 0 IP RIB Update
10 1248 97675 12 0.00% 0.00% 0.00% 0 IPC Dynamic Cach
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide