Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MC3810 does not work after password recovery

Hi, i have a router MC3810 and after password recovery it does not work any more it the console session only appears the letter cccccccccccccccccc and i can not enter in the ronmon, what can i do

1 REPLY
Hall of Fame Super Silver

Re: MC3810 does not work after password recovery

Guadalupe

The symptoms sound like the console speed got changed whle doing password recovery (probably due to mistyping the config register value - or forgetting to put 0x in front of the config register value). I would suggest that you try changing the speed of your terminal emulator (Hyperterm or whatever you use). Try speeds of 9600, 4800, 2400, and 1200. Hopefully one of these will allow you to get back into the router. With Hyperterm (and possibly some other emulators) it is helpful to stop and re-start the terminal emulator each time that you change speeds.

HTH

Rick

115
Views
0
Helpful
1
Replies