09-29-2013 01:59 AM - edited 03-04-2019 09:10 PM
Hi,
I have tried MED with ROUTE REFLECTOR in one lab,but it is not working !!!!! here is picture
My problem is I have loopbacks on R1 and want to give MED 70 on R2 and R3 30 .....so that all routers outside R100,R200 etc etc... choose R3 to reach R1 loopbacks !!!!!!!!
But this is not working
I have attched config with this message in ZIP file
Bye,
09-29-2013 05:55 AM
Hi Anand,
Remember that the metric or the 'MED' comes into play way down in the BGP path selection process - if there is a tie breaker before that, your MED value will never be considered.
From R2, R3 and any router behind it (say R100), can you post the output of show ip bgp
Regards,
Aninda
09-29-2013 08:29 PM
Thanks for reply just did it actually I didnt connect both R100 and R200 with one BGP so it was not delivering MED values
I mean when R2 give MED to R100 and R3 give to R200 ...how come R100 knows which MED values R200 has in table so that I used IBGP and now all fine as expected
Thnaks,
Bye,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide