Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Memory allocation PB on CISCO 2800 Version 12.4

Hello ;

I have the attached Memory problem on the CISCO 2800 Router ; then the telnet isnt' prossible for the routeur

Please help

thanks

1 REPLY
New Member

Re: Memory allocation PB on CISCO 2800 Version 12.4

The requested memory allocation is not available from the specified memory pool. The router memory has been exhausted or fragmented.

The smart_init is a sw module supposed to estimate the i/o size needed for a hw/sw config. It cuts a portion of the total memory
size and allocates it for the i/o pool, the rest remaining for the processor pool. The traffic pattern this router experiences might be a little bit too
bursty. To avoid that, we might want to disable the smart_init and allocate manually an amount of memory for the i/o pool.

Action plan: please enter at the global config prompt:

2811(config)# memory-size iomem 15

This will disable the smart_init module and will allocate 15% of the total dram to the i/o pool. This will clearly avoid the i/o pool size shortage and
get to the fragmentation we totally dislike.

Once configured, please reload the router to take effect the configuration.
Once done, you'll see this router run fine.

307
Views
0
Helpful
1
Replies
CreatePlease to create content