Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

memory increase to 4 G to router 3945 but show version does not show that

Hi,

Recently, I have increase to 4G memory ram to the router 3945 but when I show version, it does not state there are 4G in there but still showing the old mem ram size. Why is that so ?

Thanks

3 REPLIES
Community Member

memory increase to 4 G to router 3945 but show version does not

Hi, I'm having a similiary problem.....what did you do to resolve the issue?

Cisco Employee

memory increase to 4 G to router 3945 but show version does not

Hi,

"sh ver" not showing the DRAM size as 4 GB is expected. However, you can continue using 4 GB DRAM as it is supported.

"

Cisco IOS Software supports a maximum of 2 GB of  addressable memory. More than 2 GB of memory will be available for  future capabilities and features."

http://www.cisco.com/en/US/prod/collateral/routers/ps10538/qa_c67_553891_ps10536_Products_Q_and_A_Item.html

It will show up properly in the next generation IOS. (in development stage)

Regards,

Dheeraj

Cisco Employee

memory increase to 4 G to router 3945 but show version does not

Hello Dheeraj ,

3945E, 3925E, 3945 and 3925 all support 4 G


B DRAM but Cisco IOS Software supports a maximum of 2 GB of addressable memory. More than 2 GB of
memory will be available for future capabilities and features.  The next generation IOS will support the 4 GB.

 We know the 4 GB is installed and working because the 3900 Series uses symmetrical DIMM modules for increased performance, meaning that two
identical DIMM modules must be installed into both DIMM slots at all times.  And the router is recognizing the 2 GB which is the maximum it
will recognize in software at this time.

 http://www.cisco.com/en/US/partner/prod/collateral/routers/ps10538/qa_c67_553891_ps10536_Products_Q_and_A_Item.html

Hope this helps,

Sruthi .

1082
Views
0
Helpful
3
Replies
CreatePlease to create content