You have two IOS images on your switch. One is the .bin file, and the other is in the drwx directory. Use the "show boot" command and note down which ios is being used to boot the device. If it is the c3550-i9q3l2-mz.121-22.EA1a, then just delete the c3550-ipbasek9-mz.122-25.SEB4.bin file. If the boot ios is the c3550-ipbasek9-mz.122-25.SEB4.bin, then use the command "delete /force /recursive flash:c3550-i9q3l2-mz.121-22.EA1a". That should free up enough space to load the new IOS. After you load the new IOS, make sure you change the boot for the switch to the new IOS. Save the config and reload. After the reload, delete the old IOS file so you dont have this issue again in the future.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...