the network device has a BGP full table on it and the CEF table that is loaded on each intelligent linecard is too big for this specific linecard. This is a possible explanation.
note that if you have implemented multipath BGP with multipath as-path relax the use of memory by CEF has increased as it has to store for each IP prefix all the possible paths ===== > increased use of memory and memory issues
( I tried to guess from your other thread on BGP questions, the above may apply to you or not)
no that command should not be the root cause of high memory usage on a linecard when accepting only the default route.
About opening a service request: this can be performed or by the final customer or by the Cisco partner that sold the router to you depending from case to case. You may have to talk with your manager on how to proceed on this.
The first requesite is to have a valid maintenance contract entitled to the customer or to the Cisco partner.
A CCO account with associated the contract for the device is needed then you go to support from cisco website.
then you go to "contact Cisco for support" on the bottom of the page and you click on "open a support case".
You will be requested to identify your device using the chassis serial number, this info will be compared with the contracts associated to the CCO account you are using.
In case it is the Cisco partner that has to open the case you have to pass all the relevant information to them.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.