Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Memory

I have three routers and a couple of simple questions.

I was hoping to have more memory but alas it appears I have 32Mb Ram with 16Mb of flash in my 2610XM and 24Mb Ram and 8Mb of flash in my 2610.

What is the best image I can put on these, I am thinking of putting the 2610XM memory in the 2610 and running 12.3 and upgrading the 2610XM to 128Mb DRAM and 32Mb Flash.

Also any issues running FR on a 2510?

cisco 2610XM (MPC860P) processor (revision 0x100) with 26624K/6144K bytes of mem

ory.

Processor board ID JAD0626CJ8S (2478210345)

M860 processor: part number 5, mask 2

Channelized E1, Version 1.0.

Bridging software.

X.25 software, Version 3.0.0.

Primary Rate ISDN software, Version 1.1.

1 FastEthernet/IEEE 802.3 interface(s)

1 Channelized E1/PRI port(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

cisco 2610 (MPC860) processor (revision 0x202) with 18432K/6144K bytes of memory

.

Processor board ID JAB0314051K (599344332)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 Ethernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

1 REPLY
Hall of Fame Super Silver

Re: Memory

Hello Pete,

you can move the memory chips but only two slots are present on the C2600

see

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/cnfgnote/2600mem.htm

You should be able to use FR on the C2510

Hope to help

Giuseppe

93
Views
0
Helpful
1
Replies
CreatePlease to create content