Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Message when issuing write command Cisco 2950 switch

When issuing the write command on Cisco 2950 switch i receive the following message:

% Warning: Saving this config to nvram may corrupt any network management or security files stored at the end of nvram. Continue? [no]:

% Configuration buffer full, can't add command:tacacs-server host {ip address} %Aborting Save. Compress the config.[OK]

I haven't selected yes on the above as unsure of the cnsequences.

The Cisco 2950 switch is running with version:

flash:c2950-i6q412_mz.121-19.Ea1a.bin

Version 12.1(19)EA1a

Thanks

Martin

1 REPLY
Bronze

Re: Message when issuing write command Cisco 2950 switch

Seems like you are running out of nvram memory on this switch. You can use ' service compress-config' command in global config mode to compress existing config. This can free up space for new configuration command.

846
Views
0
Helpful
1
Replies