I have one particular site over our Metro-E (one of many) that users are complaining is really slow - i can see that the physical Metro interface at the remote site is showing about a 4-5% rate of interface errors and CRCs which is usually speed/duplex issue (we have been hard set to 100/Full for as long as can remember). However on the Vlan interface for the Metro I am seeing a large amount of IP Multicast packets so i assume I have a multicasting issue at the site. I am more of a voice/WLAN guy so any tips on how to troubleshoot and/or resolve would be appreciated - the interface summaries are below. I cleared the counters about 10 minutes ago
Metro VLAN show int
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:20:16
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.