Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGX 8850 -- common trap list needed

We're deploying MGX 8850 (5.2.10) and CWM (15.1.50). I'd like to provide our NOC with a list of traps they'd be most likely to see. An exhaustive list is too long; has anyone compiled the common ones?

2 REPLIES
Silver

Re: MGX 8850 -- common trap list needed

The Cisco MGX 8850 AXSM Enhanced (AXSM-E) ATM Switching Module is a high-density, double height service module for use in the Cisco MGX 8850 Multiservice Switch in combination with the high-capacity PXM-45 processor switching module. The AXSM delivers connectivity from T1/E1 to OC-12c/STM-4. Up to 12 AXSM modules can be accommodated in the MGX 8850 to provide the aggregation required by service providers. The AXSM Enhanced ATM Switching Module, in conjunction with the PXM-45, AXSM (Broadband ATM Switch Service Module), and Route Processor Module (RPM), offers the industry's most advanced and reliable ATM networking features, such as Private Network-Network Interface (PNNI), switched virtual circuit/path (SVC/SVP), soft permanent virtual circuit/path (SPVC/SPVP), and Multiprotocol Label Switching (MPLS).

http://www.cisco.com/en/US/products/hw/switches/ps1938/products_data_sheet09186a00800887a9.html

New Member

Re: MGX 8850 -- common trap list needed

What's your typical config per system ? They will vary widely based on each system layout

rgds

Joern

jpasche@switchxchange.com

99
Views
0
Helpful
2
Replies
CreatePlease to create content