Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGX 8850 RPM_PR slave to AXSM master cross connect

While creating the master end of a cross connect between a RPM_PR & AXSM I am getting the following error:

addcon 8 0 50 5 1 -slave 4700918100000000016444472000000107730100.0.50 -lpcr 4000 -rpcr 4000 -lscr 4

000 -rscr 4000

ERR: Error in traffic parameters (dcmp)

The RPM sub interface configuration is:

interface Switch1.1 point-to-point

description Cross connect to AXSM

ip address 192.168.1.1 255.255.255.252

no ip route-cache

pvc 0/50

oam-pvc manage

encapsulation aal5snap

!

switch connection vcc 0 50 master remote

pcr 4000

scr 4000

rpcr 4000

rscr 4000

I am not sure why I am getting this error, can anyone help with this?

4 REPLIES
Bronze

Re: MGX 8850 RPM_PR slave to AXSM master cross connect

It appears that the PNNI and AXSM DBs are out of synch. Could you please do ----- "dspcon 12:2.1:9 15 148" , on the PXM

and check if this connection exists ?

New Member

Re: MGX 8850 RPM_PR slave to AXSM master cross connect

I am not sure which connection you are referring to, but the problem I was having was a result of a missing statement.

interface Switch1.1 point-to-point

description Cross connect to AXSM

ip address 192.168.1.1 255.255.255.252

no ip route-cache

pvc 0/50

vbr-nrt 1696 1696 100 <-- was missing

oam-pvc manage

encapsulation aal5mux ip

!

switch connection vcc 0 50 master local raddr xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

pcr 4000

scr 4000

rpcr 4000

rscr 4000

rmbs 100

The question I have now is: what PVC encapsulation type should I use on this subinterface to terminate a PVC coming from FRSM configured for frame forwarding?

I am currently using aal5mux ip but the PVC is showing failed.

New Member

Re: MGX 8850 RPM_PR slave to AXSM master cross connect

Hi Smith

Please try this one

addcon if vpi vci NSAP -lpcr -rpcr -lscr -rscr -lmbs -rmbs

regards

pawan

New Member

Re: MGX 8850 RPM_PR slave to AXSM master cross connect

A couple of things...

On the AXSM you set the Service Type = 5 nrt-VBR.1, however on the RPM you have not set the corresponding parameter. Example IOS command in PVC config mode is:

vbr-nrt

If you do not set the QoS param on the RPM, it will default to UBR with 100% PCR bandwidth, hence "error in traffic parameters" which refers to both the QoS value and the Cell Rates.

If you select vbr-nrt on the RPM the corresponding AXSM QoS is nrt-vbr.3 - option 7.

Be sure to match the cell rates exactly. Cell rates entered in PVC config mode are Kbps for output-PCR and output-SCR and cells for output-MBS.

Values entered in switch conn config mode are cells!

265
Views
0
Helpful
4
Replies