Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MGX Problem

Dear all,

When I applied command dspcon 20:1.3:3 1 1979

Port Vpi Vci Owner State Persistency

----------------------------------------------------------------------------

Local 20:1.3:3 1.1979 MASTER OK Persistent

Address: 55.003004030010100333609000.0000010b2d02.00

Node name: ftwotx90

Remote Routed <<< 1.447 SLAVE -- Persistent

Address: 55.003004030010100333602000.000001012d0b.00

Node name: ftwotx20

Can anyone advise what does Routed mean? why it not shows 'slot and port' number.

Thank You!

2 REPLIES

Re: MGX Problem

Hi,

this could refer to a SPVC routed by PNNI between two MGX Switches. If this seems unfeasable could you please provide more information about the network, MGX hw/sw and the like.

Regards, Martin

Silver

Re: MGX Problem

Hi!

Greetings!

Good day! Are you mapping your PVC statically or did you use PNNI? PNNI on ATM is like a routing protocol comparable to EIGRP in IP networks, so if you see this kinds of displays, it means that you have created a PVC that is dynamically routed through the ATM network by an ATM routing protocol.

Hope this helps,

Regards,,

Albert

97
Views
0
Helpful
2
Replies
CreatePlease login to create content