I have MGX8250 and recently i have inserted in VISM-8E1 card . Presently the VISM -8E1 card is in BOOT mode . I am not sure how do i burn a firmware into that . in MGX8850 setrev is the command . I have found in MGX8250 documentation in Cisco site and the command is commit sm <rev> . I have applied that but the command is not going thru . Can you please let me know the exact command .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...