Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Microsoft Network Load Balancing

Hello. I need help.

I have a cluster running windows 2003 server which are in a Catalyst 3560G and belong to VLAN named "servers".The Network Load Balancing cluster hosts are connected to the Ethernet switch (3560G)

which is connected to a centralized Ethernet Routing Switch (Catalyst 4510R)using a single uplink port

trunk. Clients are connected to Catalyst 4510R directly and others layer 2 swichtes Catalyst. I want to deploy Microsoft Network Load Balancing using mode Multicast. How can I do it?. What configuration have I to do in the switches (Catalyst 4510R and 3560G)?.

Thanks

4 REPLIES
New Member

Re: Microsoft Network Load Balancing

I just setup an MS NLB in unicast mode and I didn't have to change a thing.

Really I would just make sure that there aren't duplicate ARP entries for the cluster IP address. Only have the new multicast ARP entry in the ARP table for that specific IP address.

Bryan

New Member

Re: Microsoft Network Load Balancing

hello Bryan, it's possible to setup MS NLB whith C2960 and C2970 cisco switch's

thank's

Re: Microsoft Network Load Balancing

Hi,

I always use the attached document for any multicast clustering of firewalls. Might be able to help you.

Also, this link may help you http://technet2.microsoft.com/windowsserver/en/library/12fb5106-d068-4a03-9864-cf5da9e31e851033.mspx?mfr=true

Regards,

Dandy

New Member

Re: Microsoft Network Load Balancing

Ok thank's

i will try.

2948
Views
0
Helpful
4
Replies
CreatePlease to create content