We have alot of users connected to two routers, we are planning to migrate them to newer Router. All users using static ip address. The problem is that, after we migrate all users from one router to other, the user devices (cisco routers, etc) will have old ARP Entry. The interupt to them should be as smaller as posible. Guys, i need you ideas, how I can force users to relearn ARP entries? Thanks
yeah it was considered too. but the problem is that new router will have users from three old routers, so now there are three different gateways and mac addresses. So this variant is not considered any more...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...