Missing cef table error message

[kenet]

Hi,

I'm getting quite a few error message like this:

%FIB-4-FIBCBLK: Missing cef table for tableid 196 during CEF samecable event

We have an MPLS-core and are using 3550 as L3 distribution switches running BGP. The error messages comes from some of the 3550-switches, but not all of them.

Any ideas or solutions?

Best regards,

Morten Madsen, Copenhagen Energy

[stephtchoko]

Find below the explanation of error:

Error Message

%FIB-4-FIBCBLK : Missing cef table for tableid [dec] during [chars] event

Explanation An internal software error has occurred.

Recommended Action Copy the error message exactly as it appears on the console or in the system log, contact your Cisco technical support representative, and provide the representative with the gathered information

You can find this explanation on :

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_system_message_guide_chapter09186a008009e770.html#347811

Contact your technical support.

Best regards.

[kenet]

OK, thanks, but what I really wanted to know was: has anybody experienced the same errors, and if so: how do I solve the problem?

Best regards, Morten Madsen

[s.vyas]

do u have VRF configured on your router ? Or all VRF config is on PE?(Router in concern) This means you have entris in FIb but does not have path in the routing table.

check sh ip cef | inc (error add)

Do u use any re-distribution in to BGP with access-list?

Like ospf routes re-distri in to mpls cloud?