Has anyone ever encountered a missing character in a device command prompt? I have a 2821 router that will not display the "#" character or the ">" when I ssh to it. The hostname is correct, but the prompt character after the hostname will not display. If I go into config mode, the "#" shows up after the (config), but in regular mode or enable mode, no prompt charater after the hostname. Has anyone ever encountered this?
I have 300 other 2821 routers and 3560 switches and this is the only device that this happen to. I use secureCRT for all my ssh connections, and I don't think it is the terminal setup because I see it with putty and teraterm, too. I have reloaded the router hoping it would fix it....no luck.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.