Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

MLDv2 configuration commands

What are the basic configuration commands to enable MLD based IPv6 multicast on an interface???

I have the following config :

ipv6 multicast-routing (globally)

interface GigabitEthernet1/0

no ip address

negotiation auto

ipv6 address 2000:104::1:1/128

ipv6 mld join-group FF1E::1

I am supposed to join a multicast group FF1E::1.Is this configuration sufficient enough???

1 REPLY
Silver

Re: MLDv2 configuration commands

93
Views
4
Helpful
1
Replies
CreatePlease to create content