Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

MLPPP configuration

All,

I have an existing mlppp configuration, and we're installing another vwic2 into the router. I don't believe this is going to be in issue, but I wanted to verify my config:

The existing config (chopped down)

int multi1

ip address x.x.x.x x.x.x.x

ppp multilink

ppp multilink group 1

int s0/0

no ip address

ppp multilink

ppp multilink group 1

int s0/1

no ip addr

ppp multilink

ppp multilink group 1

This is the existing from memory. The question is, is the following the correct way to add another link? I need it to be separate from my existing one:

int multi2

ip address x.x.x.x x.x.x.x

ppp multilink

ppp multilink group 2

int s1/0

no ip

ppp multilink

ppp multilink group 2

int s1/1

no ip

ppp multilink

ppp multilink group 2

This is the first time I'm setting this type of configuration up, but I figure that I'm just assigning my serial interfaces to a named group under the multilink interface.

Thanks,

John

HTH, John *** Please rate all useful posts ***
2 REPLIES
Hall of Fame Super Silver

Re: MLPPP configuration

John

This looks right to me.

HTH

Rick

Re: MLPPP configuration

Thanks Rick. It wasn't a trick question, I just wanted to verify my thoughts (and what I had already told someone else). :-)

John

HTH, John *** Please rate all useful posts ***
393
Views
5
Helpful
2
Replies