cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
555
Views
5
Helpful
2
Replies

MLPPP configuration

John Blakley
VIP Alumni
VIP Alumni

All,

I have an existing mlppp configuration, and we're installing another vwic2 into the router. I don't believe this is going to be in issue, but I wanted to verify my config:

The existing config (chopped down)

int multi1

ip address x.x.x.x x.x.x.x

ppp multilink

ppp multilink group 1

int s0/0

no ip address

ppp multilink

ppp multilink group 1

int s0/1

no ip addr

ppp multilink

ppp multilink group 1

This is the existing from memory. The question is, is the following the correct way to add another link? I need it to be separate from my existing one:

int multi2

ip address x.x.x.x x.x.x.x

ppp multilink

ppp multilink group 2

int s1/0

no ip

ppp multilink

ppp multilink group 2

int s1/1

no ip

ppp multilink

ppp multilink group 2

This is the first time I'm setting this type of configuration up, but I figure that I'm just assigning my serial interfaces to a named group under the multilink interface.

Thanks,

John

HTH, John *** Please rate all useful posts ***
2 Replies 2

Richard Burts
Hall of Fame
Hall of Fame

John

This looks right to me.

HTH

Rick

HTH

Rick

Thanks Rick. It wasn't a trick question, I just wanted to verify my thoughts (and what I had already told someone else). :-)

John

HTH, John *** Please rate all useful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: