I am experiencing many packets drop when I configure interface Multilink with only one physical link.The hardware is 7606 with SUP32 and IOS version 12.2(18)SXF9.I don?t have packet drop when configure IP Address in the physical link (no MLPPP in use).In the output below, you can see that the drops occur in the Multilink interface, in the physical interface I don?t have drops.
The drops occur in the input direction. In the other end has no drops.
A#ping 220.127.116.11 repeat 100
Type escape sequence to abort.
Sending 100, 100-byte ICMP Echos to 18.104.22.168, timeout is 2 seconds:
The thing is that even is possible that pings locally source from router to router can have an anomaly like these drops, that doesn't necessarily means the traffic carried across does suffer of the same problem.
So you should execute a test with external devices end-to-end to see if it happens as well.
In any case, even if you don't configure MLPPP, the router will lad balance over the two circuits and you should have no issues.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...