Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MLPPP for 2514?

Think back...2514 with two serial ports, can I bind two DS1's together with MLPPP on this old platform? I have found references for multi-chassis multi-link but I'm not sure its the same thing.

Thanks,

Bill

1 ACCEPTED SOLUTION

Accepted Solutions

Re: MLPPP for 2514?

I don't believe so. MLPPP was introduced in 12.2.8T for most routers (while it was released in 12.0S for the 7xxx series). The 2514 doesn't support anything in the T train.

You can see the specifics in http://www.cisco.com/en/US/docs/ios/12_2t/12_2t15/feature/guide/mplsdmlp.html

Rate if that helps. Thanks!

6 REPLIES

Re: MLPPP for 2514?

I don't believe so. MLPPP was introduced in 12.2.8T for most routers (while it was released in 12.0S for the 7xxx series). The 2514 doesn't support anything in the T train.

You can see the specifics in http://www.cisco.com/en/US/docs/ios/12_2t/12_2t15/feature/guide/mplsdmlp.html

Rate if that helps. Thanks!

New Member

Re: MLPPP for 2514?

Software advisor reports 12.0(17) has MLPPP for 2514 but I can't download it. Checking with 12.1(5T)

New Member

Re: MLPPP for 2514?

I give up...I would have to upgrade DRAM and Flash even if I did find an IOS that I could download. its looks like its supported (from software advisor anyway)

New Member

Re: MLPPP for 2514?

Your link references MLPPP for MPLS, not the same thing. MLPPP was introduced much earlier.

Bill

Re: MLPPP for 2514?

If you have the router with you, why can't you just use a "interface multilink 1" and see if it creates the interface? You'll get your a

nswer in a few seconds and it won't even affect your production traffic.

New Member

Re: MLPPP for 2514?

Thats the thing, I don't have the router with me and don't have access to it. I am trying to do a bit of research before hand. Your answer is right on though, I will try to add an mlppp interface first thing. Can't expect much performance but hey...

Bill

252
Views
0
Helpful
6
Replies