10-03-2007 08:07 PM - edited 03-03-2019 07:01 PM
hi,
I have two t1's bonded together using MLPPP. I have all the interfaces, Serial0, Serial1, MLPPP all show up and up.
the issue is I can not send any traffic over the mlppp circuits, I try to ping across but no luck. Attached is my show run and show multilink. Any help would be great.
10-03-2007 10:01 PM
hi
can you check the config line under multilink interface ?
ip address 10.10.10.2 255.255.255.0
is its coz of some typo ? whats the ip address configured at the other end ?
do check this and correct it out that may solve your problem.
regds
10-04-2007 02:35 AM
Try clearing the multilink bundle
clear interface multilink
Can you post a sh ip route?
Narayan
10-04-2007 04:02 AM
yes this ip is correct. The other side is 10.10.10.1
Not sure why but when we put in the shoretel voip system they said I had to bridge the two networks instead of just using routing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: