Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MLPPP routing issue

hi,

I have two t1's bonded together using MLPPP. I have all the interfaces, Serial0, Serial1, MLPPP all show up and up.

the issue is I can not send any traffic over the mlppp circuits, I try to ping across but no luck. Attached is my show run and show multilink. Any help would be great.

3 REPLIES

Re: MLPPP routing issue

hi

can you check the config line under multilink interface ?

ip address 10.10.10.2 255.255.255.0

is its coz of some typo ? whats the ip address configured at the other end ?

do check this and correct it out that may solve your problem.

regds

Re: MLPPP routing issue

Try clearing the multilink bundle

clear interface multilink

Can you post a sh ip route?

Narayan

New Member

Re: MLPPP routing issue

yes this ip is correct. The other side is 10.10.10.1

Not sure why but when we put in the shoretel voip system they said I had to bridge the two networks instead of just using routing.

109
Views
0
Helpful
3
Replies