Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Module 6748 Catalyst

Dear All, How i ussualy use 6748 module in catalyst 6500. but i want to install it in 7600 router. how to make it layer 3 interface(routed port/real port). whats the different when this module implemented in 7600 router. is there any pro and cons using this 6748 module? or is it better to use SIP ? tx

2 REPLIES
Hall of Fame Super Bronze

Re: Module 6748 Catalyst

how to make it layer 3 interface(routed port/real port)

Same as the 6500 switch:

interface gx/x

no switchport

ip address x.x.x.x y.y.y.y

is there any pro and cons using this 6748 module? or is it better to use SIP ? tx

You rely on the PFC QoS while with SIP, you can implement hierarchical QoS. I'm sure there are other differences but that's the only one that comes to mind w/o extensive searching :)

__

Edison.

Cisco Employee

Re: Module 6748 Catalyst

Hi, the 6748 line cards will work and behave the same on the 7600's as the 6500's.

To make it work as L3 interfaces, issue the following interface level commands:

no switchport

ip address x.x.x.x y.y.y.y

no shut

If you are doing QoS, it is better off to use the SIP, because the 6700's does not support shaping.

HTH,

jerry

159
Views
0
Helpful
2
Replies
CreatePlease login to create content