Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Module removal config stays

If I remove a module from cat65k will the configuration be there of the module?Logically it should loose the config?

Also if I replace STM-1 card or for eg anyother wan card in 76xx will the configuration be there?In the case of replacement it should be there.Any confirmation on this?

1 REPLY

Re: Module removal config stays

Hi

AFAIK you need to reset the switch/router to flush off the config lines related to the card removed.

regds

224
Views
0
Helpful
1
Replies
CreatePlease to create content