I want to monitor Jitter in Newly Place WAN Link performance at Branch Router. At the moment Im monitoring both the WAN Edge and the Branch router, but PE1 and PE2 administered by another party. I have few doughts once Im monitoring the jitter.
1) What Router should I configure IP sla responder ( Branch Router ) ?
2) Where should I configure IP SLA (WAN Edge / PE1 / PE2 ) ? What should I use as a port in the IP SLA ?
You should configure the Branch router as an ip sla responder. This router replies to the ip sla packets required for jitter measurments.
I recommend to configure the WAN edge as an ip sla router since the PE as you mentioned are administrated by another party. Moreover I assume that the WAN edge is located to customers HeadQuarters so it is common practice to place tha SLA tests (shadow router) there.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...