Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

monitor session

Hi guys,

I'm having hard time to make my voice recorder works with CME.

The CME is connected to port 5 on a 3560 cisco switch while the Exacom voice recorder is connected to port 30.

Here is the command i passed in the cisco switch:

monitor session 1 source int gi0/5 both

monitor session 1 destination int gi0/30

The voice recorder is able to recorde only one end of the call. I'm wondering if i need to add certain commands on either the cisco switch, or the CME.

any ideas?

1 REPLY
New Member

Re: monitor session

Try enabling inpkts

monitor session 1 source int gi0/5 both inpkts enable

This will look at both ingress and egress packets on the interface.

371
Views
0
Helpful
1
Replies
CreatePlease login to create content