Each protocol uses a different metric. Lack of metric information when introducing routes into a protocol can cause adverse effects, in some cases routes will not be advertised due to lack of metric information.
If you don't want to set the metric under the route-map, you can set a global default metric under the EIGRP process.
If you're redistributing, it will affect the AD. The set metric clause under the route map will set the metric to what you want, but the internal eigrp routes with an AD of 90 will always beat the redistributed route of 170 unless you change your external distance to 90 and then metric would come into play...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...