Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Moving static route to a new CE break the network

Hi Guys,

I hope you can help.

I've upgrade the CE from 3825 to 3925 but we have a problem .

The router is connecting to an MPLS cloud.

We have 10 static route in the old one which we need to move them to the new router, two of these static route, when I apply them to the new router a lot of drops can been seen, again when i remove them everything wrok normal.

I've check the BGP routing tabe and Im sure the the network is not learned anywhere but the new router .

When I remove the router cuasing the problem, and tray to traceroute the netwrok it send me to the default router in our data center (which mean the the mpls dont know what to do with the traffic-which is good), but again when I add the static route again to the CE everything start to go bad (alot of drops).

Thanks,

  • WAN Routing and Switching
1 REPLY

Moving static route to a new CE break the network

Hi Khaled,

Could you upload your topology and config so we can visualize what is going on, thanks.

Best Regards

Please rate all helpful posts and close solved questions

Best Regards Please rate all helpful posts and close solved questions
113
Views
0
Helpful
1
Replies