Where does a FR switch sit in relation to a provider's network? Does it sit on the edge or behind a router? If it sits on the edge, how do I keep the customers in a VRF? Do I only map from the customers perspective to the PE router?
PE1 ----> FR SW ---> Customer 1
I'm assuming that in the FR switch, I'd have dlci PE1 --> Customer1 and PE1 --> Customer2. Is that all that's required? What about LMI and Inverse ARP? Disable?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...