Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

mpls auto-template mtu 17916??

Hi There,

Anyone know where the mtu 17916 comes from when setting up an mpls auto-tunnel template?

Im running mpls auto-tunnels and when i setup the auto-template, it seems to give me a default mpls mtu of 17916.  Any idea where this mtu value comes from? is it a cisco default?  This only popped in after the ios upgrade to 12.2(33)SRE1 on a 7609S router.


## CONFIG SAMPLE ##

interface Auto-Template1
ip unnumbered Loopback0
mpls ip
mpls label protocol ldp
mpls mtu 17916
tunnel mode mpls traffic-eng
tunnel destination access-list 1
tunnel mpls traffic-eng autoroute announce
tunnel mpls traffic-eng path-option 1 dynamic
tunnel mpls traffic-eng fast-reroute
end

Is this the default behaviour? should i be reducing this? seems a tag high.

Best Regards,

Chanuka

1 REPLY

Re: mpls auto-template mtu 17916??

Hi

For MTU 17916 there is not document , As per my you should take it as default behaviour or if you are facing any issue the you can configure statically.

With tunnel interface some time it take default MTU 17916.

Regards

Chetan Kumar

http://chetanress.blogspot.com

498
Views
0
Helpful
1
Replies