Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

MPLS Circuit. Problem with Routing through the cloud

Hello,

I just had my first MPLS Circuit turned on. I can ping the other side (router) with no issues. But when I setup routing to go to a server on the other side I cannot get to it.

Here's what I have on my router:

show ip route:

10.0.0.0/8 is variably subnetted, 5 subnets, 2 masks

C 10.10.1.25/32 is directly connected, Serial0/1/0:0

C 10.10.1.24/30 is directly connected, Serial0/1/0:0

S 10.10.1.28/30 [1/0] via 10.10.1.25

S 10.30.10.55/32 [1/0] via 10.10.1.25

C 10.10.1.52/30 is directly connected, FastEthernet0/0

S* 0.0.0.0/0 [1/0] via 10.10.1.53

The 10.10.1.28 is the other side of the MPLS cloudl My side is 10.10.1.26.

I added a route for the a server on the other side of the cloud (10.30.10.55) to go through 10.10.1.25. But when I try to ping from the router to 10.30.10.55 I get the following:

ping 10.30.10.55

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.30.10.55, timeout is 2 seconds:

UUUUU

Success rate is 0 percent (0/5)

I know my routes are right, So I'm thinking there is something up with the MPLS Cloud.

Any ideas?

Thanks

Mike C.

2 REPLIES
Cisco Employee

Re: MPLS Circuit. Problem with Routing through the cloud

Mike,

It looks like the router on the other side doesn't have a route to this server (10.30.10.55). Is the server directly connected to this router? Who owns this router?

Regards,

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
New Member

Re: MPLS Circuit. Problem with Routing through the cloud

Hritter,

No, the server is connected to a switch which is connected to the router. The owner is the same company, But I don't admin the router.

What route should I have in there. Here's what I have in there now:

ip route 0.0.0.0 0.0.0.0 10.30.20.2

ip route 10.10.1.24 255.255.255.252 10.10.1.30

the second route is the route for the MPLS Circuit. Again this is the remote side, not my side.

Thanks

MIke C.

144
Views
0
Helpful
2
Replies