Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

MPLS COMMISIONING ON Channelized E1/PRI port

Dear team, I am not able to commission 2mb mpls link on Channelized E1/PRI port. i tried with config are

controller e1 3/0

channel group 0 timeslot 0-30

------

interface serial 3/0:15

ip address x.x.x.x

encapsulation ppp

this is the configuration i made on the router. i require to clarify whether mpls ciruit can be through on this channalized E1/PRI port

5 REPLIES
New Member

Re: MPLS COMMISIONING ON Channelized E1/PRI port

If you are trying to get the connection of t/s as I suspect the config. would be:

controller e1 3/0

channel group 15 timeslot 15

then the inetface command to reference the channel group number as above

interface serial 3/0:15

ip address x.x.x.x

encapsulation ppp

Hall of Fame Super Silver

Re: MPLS COMMISIONING ON Channelized E1/PRI port

Hello Suresh,

after configuring a channel group 0

your serial becomes

ser3/0:0

ip address x.x.x.x

encapsulation ppp

this is because you are using it as a data link not an ISDN PRI so no channel D on 15.

Hope to help

Giuseppe

New Member

Re: MPLS COMMISIONING ON Channelized E1/PRI port

Dear Giuseppe,

"greeting" Thanks for reply.

sorry mistaken typed serial 3/0:15.

i am not able to configure the controller card with unframed. i need answer whether i can configure the 2mbps link in this E1 PRI card.

Hope u understand my question.

thanks a lot, expecting your reply.

regard

sureshkumar.b

Hall of Fame Super Silver

Re: MPLS COMMISIONING ON Channelized E1/PRI port

Hello Suresh,

the answer is yes you can use this interface in this way.

Actually I did it both for VRF links and for MPLS enabled backbone links as well

Hope to help

Giuseppe

New Member

Re: MPLS COMMISIONING ON Channelized E1/PRI port

Dear Team,

We used NM-2CE1B in cisco 3745 router, on first port is running with PRI circuit and i would like to configure the second port to 2Mbps MPLS link. whether this card will support for my requirement.

Note: ISP is given ethernet output which is terminated on patch box pannel. From there we using a cable RJ 45 to serial cable.

current config:-

#controller E1 3/0

#channel group 0 timeslot 0-30

.............xxxxxxxxxxxx.....

#interface serial 3/0:0

#ip add x.x.x.x

#encapsulation ppp

the link is not coming up. Link is working fine when we connected with another serial port with converter (E1-V.35)

regards

sureshkumar.b

427
Views
0
Helpful
5
Replies
CreatePlease to create content