Can you help? I am trying to provide backup to a remote site and the second line has been presented with a G.703 signaling on a RJ-45 interface. A few months back someone on here recommended a VWIC2-1MFT-G703 module. This module doesn't work with a 1721 or 1841 router.
Any ideas on how to get this working? The module shows in the hardware profile but doesn't show when you do a sh ip int brief.
The router sees the card now. I installed with default values. The alarm light is on (no line is connected at present) but what I am worried about is timeslots. I sued 1-31 (default E1 since I do not have any info from the providers). I hope this works when I send it to the location.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.