Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

MPLS-TE on Multilink Interfaces

I want to run mpls-te on a multilink interface with 3 T1s (4.5Mbps).

Do I apply the commands "mpls traffic-eng tunnels" and "ip rsvp bandwidth" on the virtual multilink interface or the physical interfaces itself or both?
Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: MPLS-TE on Multilink Interfaces

Hello David,

you should configure it under the only L3 object you have the multilink interface.

the same place where you would put mpls ip and so on.

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: MPLS-TE on Multilink Interfaces

Hello David,

you should configure it under the only L3 object you have the multilink interface.

the same place where you would put mpls ip and so on.

Hope to help

Giuseppe

New Member

Re: MPLS-TE on Multilink Interfaces

Thanks G.  9314 posts incredible.

175
Views
0
Helpful
2
Replies
CreatePlease to create content