Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

mrm - "Monitor source address is not configured"?

Greetings,

I'm trying to use MRM, but the "manager" doesn't seem to know it's source address, despite looking like it does.

I've tried multiple source interfaces.

-----------------------------------------ip mrm manager TEST

manager Serial0/0.1 group 225.0.0.1

senders 1

receivers 2

-----------------------------------------

R3#sh ip mrm manager TEST

Manager:TEST/1.0.0.1 is not running

Beacon interval/holdtime/ttl:60/86400/32

Group:225.0.0.1, UDP port test-packet/status-report:16384/65535

Test senders:

5.5.5.5

Test receivers:

1.1.1.1

-----------------------------------------

R3#mrm TEST start

Monitor source address is not configured

-----------------------------------------

???!!!! Another interface (loopback)

-----------------------------------------

R3#sh ip mrm manager TEST

Manager:TEST/3.3.3.3 is not running

Beacon interval/holdtime/ttl:5/86400/32

Group:239.0.0.1, UDP port test-packet/status-report:50000/50001

Test senders:

5.5.5.5

Test receivers:

1.1.1.1

R3#mrm TEST start

Monitor source address is not configured

-----------------------------------------

I've tried this on various 3640s running enterprise 12.3, and a 2500 running 12.2(32). All have the same result.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: mrm - "Monitor source address is not configured"?

Hi Dave, The below worked fine for me. The problem is with your receiver line. You also need to reference the sender-list.

ip mrm manager TEST

manager FastEthernet0/0 group 239.1.1.1

senders 1

receivers 2 sender-list 1

access-list 1 permit 5.5.5.5

access-list 2 permit 1.1.1.1

Regards

Mark

2 REPLIES

Re: mrm - "Monitor source address is not configured"?

Hi Dave, The below worked fine for me. The problem is with your receiver line. You also need to reference the sender-list.

ip mrm manager TEST

manager FastEthernet0/0 group 239.1.1.1

senders 1

receivers 2 sender-list 1

access-list 1 permit 5.5.5.5

access-list 2 permit 1.1.1.1

Regards

Mark

New Member

Re: mrm - "Monitor source address is not configured"?

Greetings,

Yes thanks Mark. It seems I missed the "sender-list 1" on the "receivers" line.

Regards,

Dave

258
Views
0
Helpful
2
Replies
CreatePlease login to create content