MTRJ and SFP modules for small workgroup switch connection
I have a server that's connected via MTRJ to a 3750 running at 100MB. We want to replace the one server with three that run at 1GB. I'm trying to find a device/solution that i can connect the 100MB MTRJ connection to a switch and the three 1GB servers (i'm locked into having to provide 1GB speed) to the same switch. What Equipment should I get?
I've seen the 3750G, and it has the 1-GB connections for servers, but I can't seem to find an SFM module to plug the MTRJ 100MB (100Base-FX) connection. Besides that, the Spec sheet only says "1GB uplinks".
On the other hand, if i went with a CE500G, the servers would have a 1GB link, and i can see from the Tech Datasheet the uplinks can go 10/100/1000. I didn't see how the MTRJ would then be connected (part number?)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...